May 17, 2020 Leave a message

Check the battery of the fire truck from the outside to the inside

Check the exterior of the fire truck battery


Check the fire truck battery for corrosion or loose joints, cracks, or loose hold-downs.


1. If the battery has been corroded, it must be cleaned with a mixed solution of warm water and baking soda. Apply grease to the outside of the joint to prevent further corrosion.

2. If the joint connection is loose, the nut of the clip must be tightened-but not too tight.

3. Tighten the pressing tool to keep the battery fixed in its position. Over-tightening will damage the battery box.


note


Before carrying out maintenance, make sure that the engine and all auxiliary equipment of the fire truck are turned off. When checking the battery, you must first remove the ground cable from the negative connector ("-" mark) and install it at the end. Be careful not to cause a short circuit when using tools.


When cleaning the battery, be careful not to let liquid get into the battery. If the battery is disconnected or weakened, after reconnecting, replacing or charging the battery, the moon roof may not be able to operate, and the blocking prevention function will not function properly. No matter what happens, the moon roof must be used. Return to normal work.



Check the interior of the fire truck battery


Check according to the indicator (see table in the lower left corner). When recharging, the battery will emit hydrogen gas. Therefore, before recharging:


1. Remove the orifice plug.

2. If you use the battery installed on the vehicle for recharging, you must confirm that the grounding cable is disconnected.

3. When connecting and disconnecting the battery charging cable, make sure that the power switch on the rechargeable battery is turned off.


note


Charging must be done in spacious locations, not in garages or enclosed rooms, because there is insufficient ventilation in those locations. Before recharging, make sure to remove the orifice plug. Do not charge the battery while the engine is running, and also make sure that all accessory equipment is turned off.


Security risks


The battery generates flammable and explosive hydrogen. When using tools, do not let the battery spark. Do not smoke or light matches near the battery. The electrolyte contains toxic and corrosive sulfur. Prevent electrolyte from contacting eyes, skin, or clothing. Do not drink electrolyte by mistake. Wear safety goggles when working near the battery. Keep children away from batteries. Check the battery condition according to the color of the indicator


Indicator color


Type A Type B status

Green blue good

Light black white need to charge, and entrust a special service station.

Colorless or light yellow red trusted special service station to check the battery.


Send Inquiry

Home

Phone

E-mail

Inquiry